Reset a file

Module removal

How to remove the airbag module on a Alfa Romeo

Bench technician guide to locating and removing the Alfa Romeo SRS airbag ECU before a crash data file reset.

Removing the Alfa Romeo airbag control module (SRS ECU) is the first step before reading an EEPROM/MCU dump and clearing crash data on the bench. This guide covers safe disconnect practice, typical module location on Alfa Romeo vehicles, and how to match your part in the AIRBAG database.

Safety: Work only on a vehicle you are authorised to repair. Disconnect the battery and wait before unplugging SRS connectors. AIRBAG is for lawful bench repair - not in-vehicle diagnostics.

Where is the airbag module on a

On most Alfa Romeo models the SRS ECU sits beneath the centre console tunnel or behind the radio stack, depending on Giulietta, Giulia, and Stelvio layouts. Exact brackets vary by year and body style, so use the workshop manual for torque and trim clips when available. Look for a metal or plastic housing with multi-pin connectors - often with yellow SRS wiring.

Step-by-step removal

  1. Battery disconnect - Isolate the negative terminal and wait at least 15 minutes.
  2. Trim access - Remove the centre console or lower dash panels needed to see the module.
  3. Photograph labels - Capture the airbag part number, Maker marks, and any Memory chip ID.
  4. Unplug connectors - Release locks on SRS plugs; do not pull on wires.
  5. Unbolt and remove - Take the ECU to the bench for reading.

Alfa Romeo-specific notes

Alfa Romeo modules are frequently Continental, Marelli-adjacent, or Bosch - match the Maker field in the database as well as the part number.

Match the dump before crash data reset

After removal, read the full memory image and confirm it matches the File size listed for your Alfa Romeo airbag part number. Learn more in how airbag ECU crash data works, then use Search & upload to submit the dump.

Find Alfa Romeo modules in the database

Filter the supported modules list by vehicle make ALFA or paste the part number into Find for autofill of Memory and size.

Need help? Contact info@torquelab.co.uk with the part number and dump size.