Reset a file

Module removal

How to remove the airbag module on a Lexus

Bench technician guide to locating and removing the Lexus SRS airbag ECU before a crash data file reset.

Removing the Lexus airbag control module (SRS ECU) is the first step before reading an EEPROM/MCU dump and clearing crash data on the bench. This guide covers safe disconnect practice, typical module location on Lexus vehicles, and how to match your part in the AIRBAG database.

Safety: Work only on a vehicle you are authorised to repair. Disconnect the battery and wait before unplugging SRS connectors. AIRBAG is for lawful bench repair - not in-vehicle diagnostics.

Where is the airbag module on a

On most Lexus models the SRS ECU sits under the centre console on IS, RX, NX, and ES platforms. Exact brackets vary by year and body style, so use the workshop manual for torque and trim clips when available. Look for a metal or plastic housing with multi-pin connectors - often with yellow SRS wiring.

Step-by-step removal

  1. Battery disconnect - Isolate the negative terminal and wait at least 15 minutes.
  2. Trim access - Remove the centre console or lower dash panels needed to see the module.
  3. Photograph labels - Capture the airbag part number, Maker marks, and any Memory chip ID.
  4. Unplug connectors - Release locks on SRS plugs; do not pull on wires.
  5. Unbolt and remove - Take the ECU to the bench for reading.

Lexus-specific notes

Lexus SRS modules follow Toyota practices - part number Find usually auto-fills Memory and size correctly.

Match the dump before crash data reset

After removal, read the full memory image and confirm it matches the File size listed for your Lexus airbag part number. Learn more in how airbag ECU crash data works, then use Search & upload to submit the dump.

Find Lexus modules in the database

Filter the supported modules list by vehicle make LEXUS or paste the part number into Find for autofill of Memory and size.

Need help? Contact info@torquelab.co.uk with the part number and dump size.